Originally Posted by
Roger
I got everything ready, I laid out the spawning mats and injected the male and female with Ovaprim at 10 am 4/11/2019. The injection procedure went as planned as I injected both male and female under the vent fin. They did not spawn until the following morning at 10 am 4/12/2019. When I saw them being active, I started gathering and preparing the knock out bath, two bowls greased with vaseline, 10 to 1 milk to water, gallon of extra water, and rubber mixing brush. About 15 minutes into the spawn I notice a little egg on the spawning brushes, so I took the female out and sedated her. However,although everything was laid out perfectly, the eggs in her stomach did not flow out? I immediately put her back in with the male. I was wondering if anyone read or experienced anything like this before?