• Amused
  • Angry
  • Annoyed
  • Awesome
  • Bemused
  • Cocky
  • Cool
  • Crazy
  • Crying
  • Depressed
  • Down
  • Drunk
  • Embarrased
  • Enraged
  • Friendly
  • Geeky
  • Godly
  • Happy
  • Hateful
  • Hungry
  • Innocent
  • Meh
  • Piratey
  • Poorly
  • Sad
  • Secret
  • Shy
  • Sneaky
  • Tired
  • Results 1 to 7 of 7

    Thread: New Pond with High PH issues

    1. #1
      hypersushi is offline Junior Member
      This user has no status.
       
      Feeling:
      ----
       
      Join Date
      May 2008
      Location
      Malaysia
      Posts
      12

      Question New Pond with High PH issues

      Greetings,

      My concrete pond (roughly 12ft x 10ft x 4ft excluding filter dimensions) was built, soaked for over 2 weeks, drained, then water jetted to remove loose sand and dirt, then refilled and has been running for over a week now (fishless). Here are my source water parameters: PH 7 and (rather high) Nitrates at 20ppm. Ammonia and Nitrites are 0ppm from the tap. Once it goes into the pond, PH goes up to 9+? (Max reading of tester is 9), ammonia and nitrite is 0ppm but I haven't got around to reading Nitrates. I am getting green water (I do not have UV).

      So I have put some water lettuce and duck weed to hopefully soak up Phosphates and Nitrates. I also put in some mature bio media hopefully to seed the new biorings and japan mat. The green water does not bother me but the high PH does. I have yet to put my oyster shells in and am concerned as it might cause the PH to go even higher. Am I correct to assume the cement is still leaching alkalinity into the water and I just need to keep flushing the pond a few times and that should do the trick? What should I do? Put the oyster shells in to stabilise/ buffer the water at the expense of raising PH?

    2. #2
      icu2's Avatar
      icu2 is online now Administrator ~ WWKC Treasurer
      is usually here but if not I'm
      probably off flying
       
      Feeling:
      Piratey
       
      Join Date
      Feb 2007
      Location
      Poulsbo, WA
      Posts
      23,326
      My block pond did the same. My source water pH is about 7.5 and after filling it shot up to over 9...
      but a couple of weeks of time (no water changes) and it was back to about 8 and has always remained
      there. I think a little time is all the concrete needs.

      Left is after filling the pond, right is after 2 weeks:

      Name:  pH lower pond.jpg
Views: 85
Size:  66.4 KB

      --Steve
      Find more about Weather in Poulsbo, WA

      "It is far better to be alone, than to be in bad company." --George Washington

    3. #3
      RichToyBox's Avatar
      RichToyBox is online now Administrator ~ WWKC BOD ~
      Koi Health Care Committee Member
      This user has no status.
       
      Feeling:
      Awesome
       
      Join Date
      Feb 2005
      Location
      Sandston, VA
      Posts
      12,575
      When concrete hydration reaction occurs (supposedly forever, but diminishing rapidly) the products of the reaction are what is known as calcium silicate hydrate gel (the part that provides the strength), calcium hydroxide and heat. The calcium hydroxide has a pH of 14. If there is sufficient bicarbonate (HCO3), then the bicarbonate gives up a hydrogen to combine with the hydroxide and make water, leaving behind calcium and carbonate which combine to form calcium carbonate. The problem is that the calcium hydroxide has two hydroxide ions and the bicarbonate only has one hydrogen, so it takes two bicarbonate ions to neutralize the hydroxides in the calcium hydroxide, yet there is only one calcium ion left to react with two carbonate ions, but it will only react with one, so there is one carbonate left. The carbonate ion has a high pH also, but if it is bonded to calcium, it is no longer an ion that contributes to the pH. To consume these additional carbonates, additional calcium is needed in the water column. The way to get the calcium is to add calcium chloride (either pool or spa hardness increaser, or some of the ice melts are pure calcium chloride). Test the water for both GH and KH. The GH will let you know when the calcium is increasing, and becomes stable, and the KH is a measure of the bicarbonates and needs to be over 100, preferably during the cycle, over 200ppm, about 12 drops on the drop type test.

      When you add the calcium chloride, you may see some cloudiness as the calcium reacts with the carbonates to make a fine powder form of limestone (calcium carbonate), but it will settle out and the water will clear again fairly quickly. Having adequate bicarb is needed for the establishment and survival of the bio bacteria and the maintenance of a constant pH.

      "Our goal is to assist with emergency and Koi health issues, as well as educate on best practices. Please help us gain a clear picture by giving the original poster time to answer our questions before offering opinions and suggested treatments."

      Zone 7 A/B
      Keep your words sweet. You never know when you may have to eat them.
      Richard

    4. #4
      hypersushi is offline Junior Member
      This user has no status.
       
      Feeling:
      ----
       
      Join Date
      May 2008
      Location
      Malaysia
      Posts
      12
      Wow Rich,

      Thanks for the very scientific explanation. Unfortunately, I am just dumb in that department on these matters. Can I use these items and dump them in the pond to get this calcium chloride or I need to buy this from a koi shop?

      1. Oyster Shells
      2. 1 small can of expired Baking Soda
      3. Over 50 expired calcium tablets (for human consumption)

      I think I should just put in the oyster shells? I was advised by one kichi to not put oyster shells first as it would shoot the PH up the roof...

    5. #5
      RichToyBox's Avatar
      RichToyBox is online now Administrator ~ WWKC BOD ~
      Koi Health Care Committee Member
      This user has no status.
       
      Feeling:
      Awesome
       
      Join Date
      Feb 2005
      Location
      Sandston, VA
      Posts
      12,575
      The oyster shell will not dissolve at the high pH levels. The 50 expired calcium pills, if you look are probably calcium carbonate, which is where we want to end up, not where we want to start. For increasing the KH, baking soda is the way to go, but buy it in larger quantities. I had not looked at your location, so I doubt that you would have the deicer, but I would think that you would have swimming pools and possibly spas, and the stores that handle their chemicals would have the hardness increaser and the sodium bicarbonate. You can probably find baking soda in large containers at a restaurant supply. Usually here a 13 pound bag costs about the same as a 4 pound box, which is about twice the cost of the 1 pound box.

      "Our goal is to assist with emergency and Koi health issues, as well as educate on best practices. Please help us gain a clear picture by giving the original poster time to answer our questions before offering opinions and suggested treatments."

      Zone 7 A/B
      Keep your words sweet. You never know when you may have to eat them.
      Richard

    6. #6
      DragonFireSG is offline Senior Member
      is fat and well fed.
       
      Feeling:
      Geeky
       
      Join Date
      Jan 2015
      Location
      Singapore
      Posts
      513
      In Malaysia, a common treatment for high pH in a new pond is to soak chopped up banana stems and pineapples in the water.

      The acids produced as decomposition products help season the new concrete pond. I vaguely recall fellow koiphen member medicine2 who is also MY based did that for his pond.

      I have seen Tesco sell baking soda in bulk bags also, so it might be worthwhile visiting your nearest outlet. I actually bought some like that in JB a while back. Luckily customs didn't disturb me about the large bags of white powder when heading back into Singapore.

    7. #7
      hypersushi is offline Junior Member
      This user has no status.
       
      Feeling:
      ----
       
      Join Date
      May 2008
      Location
      Malaysia
      Posts
      12
      DragonFireSG,

      Thanks for the low-tech suggestion. Going to chop my banana tree(s) this evening and buy some pineapples at the grocer. I did soak with pineapple skin during the two week initial soaking but I guess it wasn't enough.

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •